01-06-2019, 10:09 PM
Unfortunately,
Just as many people on this thread already fail,
it probably will not work on the "circuit diagram" you presented.
Additional parts are required.
> but I am not sure the PHY driver provided by ayufan will drive them properly.
It is confirmation with the following image.
bionic-minimal-rock64-0.7.9-1067-arm64.img.xz
https://github.com/ayufan-rock64/linux-b...m64.img.xz
o If "eht1" is changed to enable, "eth1" will work fine. ("eht1" is disabled by default)
In addition,
o The green/yellow LEDs to function as "(Link-connetion)/(Send or Recive ?)" respectively.
---
I am not a resident living in an English speaking country.
In addition, my English ability is very very poor.
Therefore, even if it is a short sentence, it takes a lot of effort to write it in English.
Please wait few days to summarizing the "circuit diagram" and important point.
Just as many people on this thread already fail,
it probably will not work on the "circuit diagram" you presented.
Additional parts are required.
> but I am not sure the PHY driver provided by ayufan will drive them properly.
It is confirmation with the following image.
bionic-minimal-rock64-0.7.9-1067-arm64.img.xz
https://github.com/ayufan-rock64/linux-b...m64.img.xz
o If "eht1" is changed to enable, "eth1" will work fine. ("eht1" is disabled by default)
In addition,
o The green/yellow LEDs to function as "(Link-connetion)/(Send or Recive ?)" respectively.
---
I am not a resident living in an English speaking country.
In addition, my English ability is very very poor.
Therefore, even if it is a short sentence, it takes a lot of effort to write it in English.
Please wait few days to summarizing the "circuit diagram" and important point.
