Cases and Enclosure Question

[tllim]

I have measured my newly arrived board and created my own drawings and 3d models.

These are all based on measuring my single board so may not be correct for other peoples boards and I obviously have no tolerance information but perhaps they will be useful to someone until the real drawings are released.

And before anyone says anything my board was 127 x 79.5mm as measured with my calipers and not the 127 x 79mm that has previously been mentioned

files can be found https://github.com/kyllikki/designs/tree...ne64_Board

Can I share your information on Pine64 wiki page?
... TL Lim

sure, its licenced as creative commons by attribution, so as long as you credit me its fine

thanks and will do the proper credit :-)