High speed I/O
#2
(01-13-2017, 12:23 PM)richw42 Wrote: I would like to design a POT for the PINE64 that requires a lot of I/O. For example, I would like to design a board that has 4 stereo (or even 8) channels of high-quality audio output. What resources of the PINE64[+] would be appropriate for this endeavor? Can some of the existing interfaces (like display or camera) be re-purposed, and is there information available about how to do this?

With the right firmware and drivers ( of your own design ) this is theoretically possible. Audio is just a special purpose GPIO pin ( register ) in the SoC; gpu.  The problem(s) that you are going to run into is that the gpu is closed hardware protected by NDA(s) and is very poorly documented. 

You would have to provide the device tree dts|dtb for the ports ( registers ) and you would have to provide the kernel interface(s) -- drivers. I am pretty certain no one has done this yet. 

Most people have some trouble setting up the audio-jack for stereo output ( rather than hdmi output ) and something like four or eight channel output is very much "out there" on the edge. Best of luck, but I have no hope for your project ( none ).

Blush
marcushh777    Cool

please join us for a chat @  irc.pine64.xyz:6667   or ssl  irc.pine64.xyz:6697

( I regret that I am not able to respond to personal messages;  let's meet on irc! )
  Reply


Messages In This Thread
High speed I/O - by richw42 - 01-13-2017, 12:23 PM
RE: High speed I/O - by MarkHaysHarris777 - 01-13-2017, 03:31 PM
RE: High speed I/O - by xalius - 01-13-2017, 05:51 PM
RE: High speed I/O - by richw42 - 01-15-2017, 04:08 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Setting a specific pin to high status when the device powered mbt28 10 14,623 10-09-2016, 03:29 PM
Last Post: mbt28
  micro SD speed stephen fleming 12 16,030 03-31-2016, 05:46 AM
Last Post: Andrew2

Forum Jump:


Users browsing this thread: 1 Guest(s)