11-22-2016, 06:59 AM
(This post was last modified: 11-22-2016, 05:39 PM by jpnh.
Edit Reason: update to status
)
uEnv.txt seems to have worked. Thank you!
The uEnv.txt file immediately after flashing the card, but before booting it in a pine, did not have an ethaddr line. I added it, changing only the last octet:
ethaddr=36:c9:e3:f1:b8:11
I made sure to do this before booting it in the pine board, just to make sure.
Thanks for the tip on Armbian! I may check it out.
**UPDATE: The ethernet problem came back again later today, so I may have spoken too soon**
I've installed the armbian ubuntu xenial image instead, and so far seems to be working better. Will update again if the issue reoccurs
The uEnv.txt file immediately after flashing the card, but before booting it in a pine, did not have an ethaddr line. I added it, changing only the last octet:
ethaddr=36:c9:e3:f1:b8:11
I made sure to do this before booting it in the pine board, just to make sure.
Thanks for the tip on Armbian! I may check it out.
**UPDATE: The ethernet problem came back again later today, so I may have spoken too soon**
I've installed the armbian ubuntu xenial image instead, and so far seems to be working better. Will update again if the issue reoccurs
