Correct Voltage For Powering From Euler??
#5
Hey , thanks a lot for the links! I had already gone through that thread with a fine tooth comb but the schematics will be of great use, thank you. Reading the thread is partly what brought about my confusion because it mentions the thicker guage RPI official PSU to be the best but specifically mentions the 5.0 volt model. The one I have is 5.1 - I don't think it will be a problem but I looked through those schematics and all I can find mentioned anywhers is 5.0v - I don't see any sort of voltage tolerance range (thats what i was looking for). I'm now a bit hesitant to use the 5.1 now.

Maybe a better way to ask this would be...

Does anyone currently run their pine on a PSU rated any higher than 5.0v? If so, what voltage? And, does it smoke?  xD

Thanks all! I appreciate all your responses.
  Reply


Messages In This Thread
RE: Correct Voltage For Powering From Euler?? - by veronicasmithen03 - 10-18-2016, 04:33 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
Lightbulb Alternate Power DC-IN on the Euler Bus also with PI filter for batt operation MarkHaysHarris777 13 15,381 12-19-2020, 09:53 PM
Last Post: evilpete
  First cable for Euler Bus power done! AVL2016 24 16,166 10-05-2016, 06:43 AM
Last Post: Ghost
  Can I Use 2 Pine Power Supplies on 1 Pine A64 Board Using the Euler Port? Bob123456789 2 2,469 05-10-2016, 05:48 PM
Last Post: Bob123456789

Forum Jump:


Users browsing this thread: 1 Guest(s)