Setting a specific pin to high status when the device powered
#11
In this case there is no way to keep it high beside external components. I think it is easier to use an attiny to have control on power management.

However, It makes it very difficult to make prototyping of an extension board because there are lots of parts which can make error.
  Reply


Messages In This Thread
RE: Setting a specific pin to high status when the device powered - by mbt28 - 10-09-2016, 03:29 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Portable USB-Powered Monitor mribunal 4 9,468 02-03-2017, 05:28 AM
Last Post: stevenmeza07
  High speed I/O richw42 3 6,369 01-15-2017, 04:08 PM
Last Post: richw42
  Setting up UART2 for Adafruit GPS hat stephen fleming 1 3,387 05-13-2016, 03:20 PM
Last Post: peterz

Forum Jump:


Users browsing this thread: 1 Guest(s)