Setting a specific pin to high status when the device powered
#2
(10-05-2016, 09:48 AM)mbt28 Wrote: Hi,

I would like to use a linbus tranceiver to boot up my pine64. When the IC senses traffic it wakes up and provides current for 20ms. When the board powered it has to set CSL/WAKE pin to high to have continues power. So how can I set a pin to high status when the board powered?

I dont want to use arduino or other microcontroller, it makes my board even more complex.

Thanks.

I may be overthinking it, but I'm imagining some sort of battery powered circuit with the receiver and a relay-- possibly optically coupled-- on a perf board that triggers the eular pins with the momentary voltage to wake your Pine, but that may be way over-engineered.
  Reply


Messages In This Thread
RE: Setting a specific pin to high status when the device powered - by HayseedGeek - 10-05-2016, 11:27 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Portable USB-Powered Monitor mribunal 4 9,458 02-03-2017, 05:28 AM
Last Post: stevenmeza07
  High speed I/O richw42 3 6,358 01-15-2017, 04:08 PM
Last Post: richw42
  Setting up UART2 for Adafruit GPS hat stephen fleming 1 3,385 05-13-2016, 03:20 PM
Last Post: peterz

Forum Jump:


Users browsing this thread: 1 Guest(s)