Z-Wave module pinout to make it compatible with Pi b+

[tllim]

There is resistors on it. And to be honest the board with the adapter doesn't fit in the official pine64 abs case.

Envoyé de mon SM-N9005 en utilisant Tapatalk

I still don't see why the Z-wave module could not be fitted directly to the 40 pin adaptor board. A few SMD resistors shouldn't be such a big problem on a board of that size. 

There is resistors on it. And to be honest the board with the adapter doesn't fit in the official pine64 abs case.

You have GOT to be kidding me ???!    (people are going to be grumpy)

Apparently not: http://forum.pine64.org/showthread.php?t...4#pid19264

---

You can see L1 (maybe an inductor as the L suggest but too tiny for me) upper the connector of the adapter on the picture.

Envoyé de mon SM-N9005 en utilisant Tapatalk

Strange. The Pine64 shop shows no adapter board:


(Nor do they show the antenna coil)

This is the previous version that using Mitsumi ZWave chip. Since Sigma Designs no longer selling the ZWave chip to Mistsumi, we force to use the Sigma Designs module.