Howto use MAC address as printed on the label on the back
#1
The BSP Linux Kernel does automatically generate a locally administered MAC address for the Ethernet (eth0) interface.

Some networks might not be able to handle those correctly. The recommended solution is to manually set the MAC address to the one which is printed on the back of the Pine64 by adding it to /boot/uEnv.txt with a line like ethaddr=xx:xx:xx:xx:xx:xx.

The MAC address is the lower number on the barcode label on the back of your Pine board. Start from the left and add a colon every two chars. So far they all seem to start with 00:06:dc making this the vendor prefix.
  Reply


Messages In This Thread
Howto use MAC address as printed on the label on the back - by longsleep - 08-20-2016, 11:13 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Howto test and tune Gigabit Networking (1000M) longsleep 16 29,123 05-18-2022, 02:07 PM
Last Post: moriel5
  Rock64: MAC Address is NOT Unique! PDXpi 3 4,839 02-01-2021, 12:12 AM
Last Post: PDXpi
  The Mac Address Would Not Change on Debian, nor Gentoo MarkHaysHarris777 5 8,897 03-27-2017, 12:57 PM
Last Post: grobbs
Question no permanent MAC address? need it to give Pine64 a reserved IP. faddah 14 23,339 08-24-2016, 03:25 PM
Last Post: MarkHaysHarris777

Forum Jump:


Users browsing this thread: 1 Guest(s)