marcushh77, thanks for you guidance, i've installed RPi.GPIO-PineA64 and i am familiar with python.
as for LED lab, the only step that works for me is constantly lit up LED (pin 1 and pin6).
i was following steps from here http://www.thirdeyevis.com/pi-page-2.php
turning LED on and off and blinking LED example did not work, my LED stays always on being attached to pin7 .
I wander if gpio pin numbers in pine are different than Raspberry pi ?
Also i did not find resistor 50 ohm, i only found 10 ohm, this is the only deviation from the lab.
Should I be connecting the wires to PI 2 Bus or Euler bus ? pins ?
as for LED lab, the only step that works for me is constantly lit up LED (pin 1 and pin6).
i was following steps from here http://www.thirdeyevis.com/pi-page-2.php
turning LED on and off and blinking LED example did not work, my LED stays always on being attached to pin7 .
I wander if gpio pin numbers in pine are different than Raspberry pi ?
Also i did not find resistor 50 ohm, i only found 10 ohm, this is the only deviation from the lab.
Should I be connecting the wires to PI 2 Bus or Euler bus ? pins ?