CR2032 Battery holder - sanity check
#24
Yes, using batteries of questionable or unknown quality/output might cause you issues, but if in parallel not anything that really worries me.

Key point here is..assembled correctly, either one battery or two will work. If using two batteries, ensure correct assembly and verify you have 3V on the connector pins (and not 6V, suggesting they are in series, or a minimal voltage output indicating they are connected with opposite polarity, or bucking), and you're fine.
  Reply


Messages In This Thread
CR2032 Battery holder - sanity check - by xalius - 07-22-2016, 04:30 PM
RE: CR2032 Battery holder - sanity check - by DonFL - 01-23-2017, 07:41 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
Rainbow Lithium battery temperature readout? GregH 0 1,848 03-12-2020, 12:05 AM
Last Post: GregH
  Lithium 3.7 Volt Battery Ron Piggott 49 65,526 07-15-2017, 03:56 PM
Last Post: tllim
  Battery level measurement? HugoRabson 2 4,148 03-08-2017, 06:30 PM
Last Post: pfeerick
  Travelling with the Pine64 (and Lipo battery) psychedup 2 4,492 02-17-2017, 08:18 PM
Last Post: tllim
  Battery temp pin? SvdSinner 1 3,770 12-13-2016, 11:35 AM
Last Post: MarkHaysHarris777
  battery power in android UnixOutlaw 40 50,811 09-25-2016, 07:54 PM
Last Post: tllim
  RTC Backup Battery - CR sbentjies 6 9,198 07-15-2016, 06:35 PM
Last Post: jwouellette
  Battery Datasheet xalius 0 2,433 06-20-2016, 07:38 PM
Last Post: xalius
  Lithium 'salt and battery UnixOutlaw 0 2,331 05-29-2016, 09:32 PM
Last Post: UnixOutlaw
  Minor note about the RTC battery MichaelMeissner 12 17,615 02-18-2016, 05:17 AM
Last Post: German

Forum Jump:


Users browsing this thread: 1 Guest(s)