PINE64   ›   Pinecil   ›   General Discussion on Pinecil   ›   Pinecil v2 power cycles at higher voltages?

Pinecil v2 power cycles at higher voltages?
RevAngel
Pine Initiate
**
Joined: Aug 2024
Posts: 2

Reputation: 0
#4
08-10-2024, 05:47 AM
pinecil v2 with latest firmware and a ugreen nexode 140W. Goes up to 28.3 Volts and therefore heats up to max 420 degrees in 4 seconds!
  Reply


Messages In This Thread
RE: Pinecil v2 power cycles at higher voltages? - by RevAngel - 08-10-2024, 05:47 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  pinecil v2 reverse polarity issue adamsk1952 0 224 09-12-2024, 07:54 AM
Last Post: adamsk1952
Sad Pinecil V2 screw broken! Carol8 1 157 09-09-2024, 08:44 AM
Last Post: Carol8
  Pinecil on Amazon? WEF 5 1,452 09-05-2024, 08:23 AM
Last Post: Jeb
Question Can Pinecil Read USB-C Cable E-Marker Chips? Garywoo 1 630 05-13-2024, 01:31 PM
Last Post: tllim
  Connecting a power supply to the Pinecil jon_bondy 1 911 02-29-2024, 07:37 PM
Last Post: Okedokey
  Best power supply? naviathan 4 5,702 02-29-2024, 07:33 PM
Last Post: Okedokey
  Crippling noise from inside pinecil during a few minutes high power soldering. dreieck 2 1,382 01-31-2024, 12:34 AM
Last Post: suga7
Question Pinecil Tempaerature Reading jumps to Y400°C when active but stays normal when cold H3wastooshort 0 658 12-24-2023, 05:45 PM
Last Post: H3wastooshort
  Asus laptop power supply can also power Pinecil biketool 9 9,900 11-17-2023, 12:57 PM
Last Post: killingmesmalls
  Mass problem Pinecil V2 Harrysteed 0 1,047 11-02-2023, 09:11 AM
Last Post: Harrysteed

Forum Jump:


Users browsing this thread: 1 Guest(s)