09-02-2022, 09:27 PM
Hi All
Been using the Pinephone daily for some time now, and also daily updates and upgrades.
About 2 months ago I started having problems after updates, so I bit the bullet and went for
a re-write of the image to the latest.
Soon discovered that Tow-Boot was now needed.
Installed as per instructions and tried it.
The main problem was that opening settings menu worked, but as soon as I selected say "Wifi",
the settings menu would close and the Wifi settings would not come up.
The only was I could get my phone back, was to install an image from May 2022 which didn't require Tow-Boot
and all worked correctly again.
However the upgrades are starting to add up to about 475, so I am sure that if I upgrade the onboard emmc
the same problem will come back.
This time I am trying to install the latest image on the micro SD to prove or find a solution to this issue.
The procedure I followed:
Wrote Tow-Boot to on board emmc. (the May image still works correctly after that) using balena Etcher
Wrote 20220821.img.gz firstly to the SD with the PC.
Booted by holding Volume down and tested to find the same problem still exists.
Then wrote the same image to the SD plugged into the phone, same problem STILL.
Here is what I don't get:
I have a stock standard PP64 phone that has the touch screen replaced (by me) that works perfectly on May 2022 images.
I write a verified image to either the phone or SD and it always fails with the same problem.
Then someone wrote about Enabling Animations (probably different issue) but the first step, Settings> Accessibility just closes
the Settings menu again. Some Settings sub menu's do work (Network for example) but 95% of them just close the Settings menu.
I can't update or upgrade as the Wifi has not been initialized.
Anybody have any ideas ?
Regards
Been using the Pinephone daily for some time now, and also daily updates and upgrades.
About 2 months ago I started having problems after updates, so I bit the bullet and went for
a re-write of the image to the latest.
Soon discovered that Tow-Boot was now needed.
Installed as per instructions and tried it.
The main problem was that opening settings menu worked, but as soon as I selected say "Wifi",
the settings menu would close and the Wifi settings would not come up.
The only was I could get my phone back, was to install an image from May 2022 which didn't require Tow-Boot
and all worked correctly again.
However the upgrades are starting to add up to about 475, so I am sure that if I upgrade the onboard emmc
the same problem will come back.
This time I am trying to install the latest image on the micro SD to prove or find a solution to this issue.
The procedure I followed:
Wrote Tow-Boot to on board emmc. (the May image still works correctly after that) using balena Etcher
Wrote 20220821.img.gz firstly to the SD with the PC.
Booted by holding Volume down and tested to find the same problem still exists.
Then wrote the same image to the SD plugged into the phone, same problem STILL.
Here is what I don't get:
I have a stock standard PP64 phone that has the touch screen replaced (by me) that works perfectly on May 2022 images.
I write a verified image to either the phone or SD and it always fails with the same problem.
Then someone wrote about Enabling Animations (probably different issue) but the first step, Settings> Accessibility just closes
the Settings menu again. Some Settings sub menu's do work (Network for example) but 95% of them just close the Settings menu.
I can't update or upgrade as the Wifi has not been initialized.
Anybody have any ideas ?
Regards