Scope for customisation
#1
Gday,

I've just laid my hands on a pinecil v2.  I have only the use of one hand due to a disabilty and started thinking whether I might be able to program some features to make soldering easier for me.  I heard someone say that there is maybe bluetooth connectivity in the unit.  Could the following scenario be possible? 
Turn the iron on and off via a remote switch?  I'm thinking I could use a "third-hand" of some kind to posistion the iron correctly and then be able to start it heating without  touching it.  I could then feed solder to a joint with me good hand.   And being able to turn it off again would be good for safety.  A bit  slow and clumsy I know but it's all i can think of fore the moment.  I've got one of the ratchet gun feeders from the like of bang good but it's note quite delicat enough and I don't have the budget at the moment for the higher end autofeeding stations.

I'd welcome some suggestions if anybody has any ideas,

Cheers
John
  Reply


Messages In This Thread
Scope for customisation - by sirjohndfox - 08-25-2022, 11:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)