06-25-2022, 11:33 AM
Hello,
I'm new with setting up a Linux distribution on a board. After receiving my two Quartz64 I tried to flash several images on a microSD and afterwards tried to boot the board. Additionally I have connected a 24" monitor on the HDMI Port, a LAN-cable at the ethernet adapter, a power adapter (12V 3.5A 42W) and mouse & tastatur at the USB-ports.
But it seems there isn't even a booting sequence, my monitor doesn't show any command line and only the power LED is shining blue.
I tried to press the power button several times but nothing seems to work. BAT_Jumper is sticked on the board too.
I tried the following OS:
I looked through several posts in this forum but couln't find an answer. From my understanding I should see at least a command line even if the OS isn't set up yet.
I tested everything with both Quartz64 to exclude the possibility that there is a boot error or any defect with my board.
Since I never have set up a board before, am I doing something fundamentally wrong?
I'm new with setting up a Linux distribution on a board. After receiving my two Quartz64 I tried to flash several images on a microSD and afterwards tried to boot the board. Additionally I have connected a 24" monitor on the HDMI Port, a LAN-cable at the ethernet adapter, a power adapter (12V 3.5A 42W) and mouse & tastatur at the USB-ports.
But it seems there isn't even a booting sequence, my monitor doesn't show any command line and only the power LED is shining blue.
I tried to press the power button several times but nothing seems to work. BAT_Jumper is sticked on the board too.
I tried the following OS:
- Manjaro-ARM-gnome-quartz64-b-20220620.img.xz
- Manjaro-ARM-mate-quartz64-b-20220620.img.xz
- Manjaro-ARM-minimal-quartz64-b-20220620.img.xz
I looked through several posts in this forum but couln't find an answer. From my understanding I should see at least a command line even if the OS isn't set up yet.
I tested everything with both Quartz64 to exclude the possibility that there is a boot error or any defect with my board.
Since I never have set up a board before, am I doing something fundamentally wrong?
