07-07-2016, 06:43 PM
(This post was last modified: 09-26-2016, 05:16 PM by Bluphire.
Edit Reason: Updated with link.
)
I received my case today from a seller by the name of The C4 Labs I found on ETSY. I am extremely impressed with the quality of the design and the materials. The only problem I encountered though was there were no cutouts for the reset/power switches. I just used a dremel and notched out the piece for my switches. I've emailed the founder of The C4 Labs about the issue and will report back when (if) I hear back. All in all, very pleased. And at just under $20/shipped, it's a wonderful case.
You can find the case HERE.
Now for the pictures:
Where the cutouts were needed:
After the cuts:
From the top (they included the heatsink with the case):
From the bottom (optional rubber feet included):
And the sides:
And the photo instructions:
Matt
*UPDATE*
See page 8 for finale LCD case design.
You can find the case HERE.
Now for the pictures:
Where the cutouts were needed:
After the cuts:
From the top (they included the heatsink with the case):
From the bottom (optional rubber feet included):
And the sides:
And the photo instructions:
Matt
*UPDATE*
See page 8 for finale LCD case design.
+1 me if I have helped you in any way. Thank you.