How do you put this together?
#3
(06-27-2016, 03:16 PM)MarkHaysHarris777 Wrote: hi  (ground yourself before doing any of this)
1) if your SD card has the Android image on it already, then just plug the micro SD into the push-push slot of the PineA64 till it clicks.
1a) ... if not, you'll have to get the Android image on the card. (that's another story)
2) plug the ribbon cable of the display into the PineA64 board DSI .   BE CAREFUL its easily broken !
3) plug the 5v power into the PineA64 micro usb connector  (dont plug into mains yet)
4) plug the wifi bt module into the PineA64 board      
5) plug the PineA64 into the mains  (wall wart into wall socket)

Do not have the ethernet hooked up on the boot-up... wait till after it boots and is running to plug that in.

Let it run for about 15 minutes at least before trying to power it off.

Its actually not that hard, but it is fragile, and it is a little finiky... be careful.

Thank you MarkHaysHarris777!

I have never assembled anything like this before, so I think I got all the stuff connected properly.

I plugged the SD card in, and it says I need to format the card before I can use it. The default is ex-FAT. Is that what I should use?


Messages In This Thread
How do you put this together? - by srosvold - 06-27-2016, 03:00 PM
RE: How do you put this together? - by srosvold - 06-27-2016, 03:52 PM
RE: How do you put this together? - by pfeerick - 06-28-2016, 02:38 AM
RE: How do you put this together? - by srosvold - 06-28-2016, 08:33 AM
RE: How do you put this together? - by srosvold - 06-28-2016, 02:28 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)