Pinetime almost dead... only shows Infinitime logo.

[alexmitroff]

Hi everyone! I faced the same issue. I was running a pine watch with 1.11.0 firmware, but then after my toddler found it they start to show infinitime logo.

I followed steps described by @barray but my GadgetBrige refuses to connect to a pine watch. It sees it, it pairs with it, but refuses to connect. And firmware update via GadgetBriges is not possible without connected device.

Then I installed ITD (v1.0.0) software on my laptop. And my laptop was able to connect to a pine watch. But I can not upgrade a firmware.

Code:

itdctl firmware version
0.14.1

itctl firmware upgrade /home/alex/Downloads/pinetime-mcuboot-app-dfu-1.11.0.zip
Upgrade command requires either archive or init packet and firmware.

I need your help, because I think miss something very obvious, but I do not know what exactly.

Additional:
I set ITD in "debug" log mode in /etc/itd.toml
Journal shows next:

Code:

Feb 11 12:34:30 pop-os itd[36368]: 12:34PM WRN Error getting BLE filesystem error="characteristic adaf0200-4669-6c65-5472-616e73666572 (Filesystem Transfer) not available

Update:
I get it done!
I borrowed a another phone. Installed GadgetBrige. It successfully connected to a pinewatch. After third attempt firmware was successfully installed. And now a pinewatch live again =) 1 attempt was upload failer. On a 2 attempt the process stopped on a 100% upload value. I restarted the watch and 3 attempt was successful.