05-20-2021, 05:44 AM
Ctrl-a then x to get out of minicom IIRC - think it's in the man page. I had trouble getting minicom's local echo to work so ended up using picocom. I don't think it's necessary but you can set the bitrate from the cli using '-b 115200' switch. Use '-c' switch on cli to enable local echo, or Ctrl-a Ctrl-c to toggle it during a session. Exit with Ctrl-a Ctrl-x. If in doubt check the man page. I assume it's the same on manjaro as mobian, which is what I was using when messing with the GPS.
