04-26-2021, 06:53 PM
Thanks LMM!
I think I've actually found the solution to my latest boot problem: if I have UART2 TX connected when I bring up the external power supply, the RP64 consistently fails to boot. Otherwise, it's booting up just fine. The wiki only mentioned UART2 RX should be disconnected during boot, so this was unexpected.
This should be easy to work around, I can probably just tri-state that pin on my microcontroller for a few seconds during power up and be OK.
This wasn't the first time I had problems booting from SD, though it was the first time I had the UART connected. I think I'll order an EMMC module just to be safe.
I'll post my project as soon as I know everything's working as it should!
ColPanic_
I think I've actually found the solution to my latest boot problem: if I have UART2 TX connected when I bring up the external power supply, the RP64 consistently fails to boot. Otherwise, it's booting up just fine. The wiki only mentioned UART2 RX should be disconnected during boot, so this was unexpected.
This should be easy to work around, I can probably just tri-state that pin on my microcontroller for a few seconds during power up and be OK.
This wasn't the first time I had problems booting from SD, though it was the first time I had the UART connected. I think I'll order an EMMC module just to be safe.
I'll post my project as soon as I know everything's working as it should!
ColPanic_