07-23-2020, 01:27 PM
So it's been my 3rd day with my Pinephone CE and I've found out a lot of stuff.
I just did the VCONN Switch removal surgery in the jankiest way imaginable since I don't have a reflow workstation at home. So far I got the phone to recognize that something was plugged in and it even charges for a brief moment from my PD power supply. After a bit of prodding around I saw that it spat out an error message:
Heck it even shows in the lines before that that it got the IRQ and even enabled power for a brief moment.
So my question now is how could I fix this? Is there an easy script to flash the firmware to this chip? I hope I didn't rip through a trace on the Board.
The device I'm trying to use is a combined USB-hub with USB-PD input and HDMI out. So kinda like the dongle from the convergence pack but different.
I just did the VCONN Switch removal surgery in the jankiest way imaginable since I don't have a reflow workstation at home. So far I got the phone to recognize that something was plugged in and it even charges for a brief moment from my PD power supply. After a bit of prodding around I saw that it spat out an error message:
Code:
anx7688 0-0028: boot firmware load failed (you may need to flash FW to anx7688 first)So my question now is how could I fix this? Is there an easy script to flash the firmware to this chip? I hope I didn't rip through a trace on the Board.
The device I'm trying to use is a combined USB-hub with USB-PD input and HDMI out. So kinda like the dongle from the convergence pack but different.