07-01-2016, 09:53 AM
No such luck here, my PINE A64+ shuts down when using a powered USB hub or won't power up if the hub is attached and already powered.
My experience with a x86_64 motherboard and a powered hub was that +5V fed back from the hub caused the +5V LED to be permanently on so I had to cut the +5V (red wire) in the PC --> Hub cable otherwise it would not power up. If I powered up and then applied power to the hub all was OK until next reboot.
I am using powered hubs with my 2 ODROID-C2's as I did with a Raspberry Pi 1 model B and Pi 2 with no problems.
My experience with a x86_64 motherboard and a powered hub was that +5V fed back from the hub caused the +5V LED to be permanently on so I had to cut the +5V (red wire) in the PC --> Hub cable otherwise it would not power up. If I powered up and then applied power to the hub all was OK until next reboot.
I am using powered hubs with my 2 ODROID-C2's as I did with a Raspberry Pi 1 model B and Pi 2 with no problems.