05-10-2016, 08:16 AM
(This post was last modified: 05-10-2016, 08:24 AM by martinayotte.)
Did you have loaded the proper kernel driver for that ?
I think the w1-gpio driver is not even enabled in the current kernel from longsleep.
You need to enable it and compile new kerne as well as to tweak the device-tree to specify which pin to use.
@peterz, you've mentioned IR receiver, but this is completely different thing, it is not using Dallas 1 wire protocol.
I think the w1-gpio driver is not even enabled in the current kernel from longsleep.
You need to enable it and compile new kerne as well as to tweak the device-tree to specify which pin to use.
@peterz, you've mentioned IR receiver, but this is completely different thing, it is not using Dallas 1 wire protocol.