Installing other USB ports
#1
Hi, 
I have the pine64+ board. It has two USB ports. I need to install an extra one or two USB ports. What is the best way to do that? Is it possible to install a USB port on any of the GPIO pins?
  Reply
#2
depending on what you need the usb ports for you might find using a powered usb hub as a solution.
  Reply
#3
(07-17-2018, 10:12 PM)dkryder Wrote: depending on what you need the usb ports for you might find using a powered usb hub as a solution.
I need to connect three wifi usb modules. The board has only two USB ports. Any suggestions?
  Reply
#4
(07-17-2018, 10:31 PM)mido2018 Wrote:
(07-17-2018, 10:12 PM)dkryder Wrote: depending on what you need the usb ports for you might find using a powered usb hub as a solution.
I need to connect three wifi usb modules. The board has only two USB ports. Any suggestions?

my guess would be that 3 usb wifi modules would be a challenge.  i have no experience with a project like that so i can offer no suggestions. but, good luck. let us know how it goes.
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)