Zwave module on LTS
#1
Hi,
Any idea if the Z-Wave module for both Pine64+ and LTS are the same? i.e. will the one bought for pine64+ work on LTS?

I currently have xenial-minimal from ayufan-pine64 repositories, ubuntu-mate installed.
I have also installed Openhabian from here (manual steps)

https://docs.openhab.org/installation/op...nual-setup.
+
Its all up and running.


When I install the z-wave binding and try to get the z-wave serial controller, it says port /dev/ttyS1 or S0 does not exist.

Any idea as to how to get this work?
The same z-wave module was working fine on another Pine64+ board

Thanks
Sailesh
#2
I don't see any problems with that since the expansion connector pinouts are all the same... maybe the devicetree files are configured differently, but from the hardware side there should be no issues...
Come have a chat in the Pine IRC channel >>
#3
Should be same between PINE A64 and PINE A64-LTS


Possibly Related Threads…
Thread Author Replies Views Last Post
  Connecting the RaspBee ZigBee module to 5V/GND on the Euler bus causes issues karlitos 0 1,814 04-22-2021, 03:05 AM
Last Post: karlitos
  Camera module with Android Kam 4 6,508 11-21-2020, 01:26 AM
Last Post: Little_Johnny
  Camera module with Arch Linux IkerST 0 2,237 05-05-2020, 08:44 PM
Last Post: IkerST
  is it possible to connect 2 Ethernet port to SOPINE module? eddylai 2 5,192 05-03-2017, 12:01 PM
Last Post: bobpaul
  Sopine Module and USB HDMI mbt28 1 4,264 01-23-2017, 08:13 AM
Last Post: MarkHaysHarris777

Forum Jump:


Users browsing this thread: 2 Guest(s)