(06-04-2018, 02:20 PM)zarusz Wrote: Does the Rock64 LibreELEC image from here (http://test.libreelec.tv/) work for anyone? 
I tried the one mentioned below, but after reboot it goes into kernel panic mode and a lot of HEX numbers are being displayed. 
LibreELEC-RK3328.arm-9.0-nightly-20180603-330aad4-rock64.img.gz

(06-04-2018, 04:27 PM)kostaman Wrote:

(06-04-2018, 02:20 PM)zarusz Wrote: Does the Rock64 LibreELEC image from here (http://test.libreelec.tv/) work for anyone? 
I tried the one mentioned below, but after reboot it goes into kernel panic mode and a lot of HEX numbers are being displayed. 
LibreELEC-RK3328.arm-9.0-nightly-20180603-330aad4-rock64.img.gz

https://forum.libreelec.tv/thread/12151-feedback-for-test-build-libreelec-rk3328-arm-9-0-devel-box-trn9-img/?postID=93393#post93393

That last Nightly was a bad one.

(06-05-2018, 01:28 PM)zarusz Wrote: Thanks for pointing out the LE relevant topic, I was not able to find anything related. It is good that the LE Rock64 image is still being developed by Kwiboo.
Two days passed and there is no new nightly build. Do you know how often or when is the next nightly build going to arrive?

(06-07-2018, 12:30 PM)zarusz Wrote: The LibreELEC work in progress are not yet in the nightly build location (http://test.libreelec.tv/). 
At this point they are made available by Kwiboo under a different location - more details in this LibreELEC post

(06-12-2018, 07:13 PM)Wizardknight Wrote: Are you sure?
I see this 'LibreELEC-RK3328.arm-9.0-nightly-20180612-a0d6cb2-rock64.tar' in http://test.libreelec.tv

(05-14-2018, 11:51 AM)gigagames Wrote: Hello,
hope its ok to post my problems here

Problem 1:
I tried to install
-leia24
-some nightbuilds from test.libreelec.
They doint boot from eMMC (Red + White led lit forever and nothing happens) I only can boot them if i insert a SD-Card, Install a Jumper on eMMC "pins" and remove the jumper directly when i start.
Or if i install leia21 -> Boot -> go into a linux build -> mount the eMMC p1 and the img from the libreelec build i want and copy the Image / System files to the eMMC (replace them from the installed leia21 build)

Problem 2:
I got Inputstream.adaptive running (why is it not in all this builds ...?)
If i have hardware acceleration - PRIME active and Try to change the Source, i got a blackscreen my monitor says no signal. And i never get the image back (need to restart)
In the logs i get WARNING: CRenderManager::WaitForBuffer - timeout waiting for buffer

If i deactivate hardware acceleration, it works without any problems (only 90-100% cpu load..)

If i now reactivate hardware acceleration, the video starts playing with the settings i set before. But when i close it / it ends. Same behaviour (blackscreen and only restart helps)

Is there a solution that i can add ?