pbp no longer boots - Printable Version +- PINE64 (https://forum.pine64.org) +-- Forum: Pinebook Pro (https://forum.pine64.org/forumdisplay.php?fid=111) +--- Forum: General Discussion on Pinebook Pro (https://forum.pine64.org/forumdisplay.php?fid=112) +--- Thread: pbp no longer boots (/showthread.php?tid=12380) Pages:
1
2
|
RE: pbp no longer boots - xyzzy - 12-02-2020 If you get boot logo, then the kernel is starting (if it's the bootsplash), or userspace is running if it's the desktop starting screen. So you've gotten significantly farther than u-boot. That really points to a battery problem. Power draw will go up as the GPU is enabled and all the CPU cores run stuff during start up, where you had the crash. One could try measuring battery cell voltage and see if it's dropping too low. There's an alarm signal for SOC and RTT on the battery monitor. Too bad they don't go to a LED. RE: pbp no longer boots - tulsums - 12-03-2020 (12-02-2020, 06:36 PM)wdt Wrote: I don't know about usbC, but if you leave barrel charger in a long time, red (charge) led WILL go out (pbp off)hi thanks! I have a couple clarifying questions. This releaseĀ https://github.com/mrfixit2001/debian_desktop/releases/tag/191226 is the one you mean? I don't understand what you mean by his update? Flip the switch while booted into that debian sd? what do you mean by rebind? I do have another linux machine. I'm not sure how to check that extlinux root= and fstab is right. I know that's a lot of questions if you send pertinent documentation I can read that instead. okay so after sitting with the barrel charger plugged in for over 36 hours I tried again with my usb c power bank (18 w pd quick charging) plugged that in and it booted! says battery is at 1% (up from 0%) and charging now. Could my barrel charger be defective? or my battery be dead/dying? I did notice that the red charging light blinks with the barrel charger. is that normal? I'm going to leave it on the usb c charger for a while. is there any wiki documentation of these battery issues? I'll submit a PR to update the documentation if there isn't. should this be in the troubleshooting doc? https://wiki.pine64.org/wiki/Pinebook_Pro_Troubleshooting_Guide#Pinebook_Pro_will_not_power_on_after_toggling_the_eMMC_enable.2Fdisable_switch RE: pbp no longer boots - wdt - 12-03-2020 Blinking indicates a fault,,info, https://www.ti.com/lit/ds/symlink/bq24171.pdf?ts=1594818438989&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252FBQ24171 Does it blink with usbC? One person found that with a full charge with usbC, then barrel charger worked OK again Yes, that is the mrfixit distro, the update is kernel and uboot, uboot IS installed (IIRR /usr/bin/mrfixit_update.sh,, NOTE, only applies to THIS distro) bind.... if you don't get switch timing right (emmc off,, 2 second window to switch on,, emmc is present) then,, emmc switch on echo fe330000.sdhci >/sys/bus/platform/drivers/sdhci-arasan/{un,}bind But you don't need to do this, you have a charging problem, not a bad uboot on emmc problem |