PINE64

(09-20-2019, 04:29 AM)loki21century Wrote: [ -> ]Hi all,

I have just purchased a new Pine64 board with 2gb ram and a new power supply.  I powered it up and installed OVM  on it.  It was running fine for 4 hours and then it switched itself off.  The board is no longer powering up, the on board red light is not coming on.  I've disconnected everything and re attached it all again and plugged the power supply into the power socket and switched on but nothing. Would anyone be able to assist.

(09-26-2019, 09:21 PM)tllim Wrote: [ -> ]

(09-20-2019, 04:29 AM)loki21century Wrote: [ -> ]Hi all,

I have just purchased a new Pine64 board with 2gb ram and a new power supply.  I powered it up and installed OVM  on it.  It was running fine for 4 hours and then it switched itself off.  The board is no longer powering up, the on board red light is not coming on.  I've disconnected everything and re attached it all again and plugged the power supply into the power socket and switched on but nothing. Would anyone be able to assist.

i have been having a similar issue to this. 
sometimes my PineA64 does not boot and on pressing the power button displays the red light fir a few seconds and then it goes off. 

I have noticed if I unplug the power cable from the board and then plug it back in it will boot fine. 

I am using Volumio but this also occurred with Android. I am using the original powers supply that was shipped with the board so I assume no issues here. 
any ideas?