PINE64

Full Version: Problems with maskrom OTG USB in Linux - Device not responding to setup address
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hi everybody

I have problem with RockPro init in maskrom mode.
Whe I try to set MASKMODE - my Linux machine connected to OTG port observe new USB device but cannot initialize it. The messages are:

Aug 31 19:37:27 asx-comp kernel: [30550.996297] usb 1-2: new full-speed USB device number 84 using xhci_hcd
Aug 31 19:37:27 asx-comp kernel: [30551.596303] usb 1-2: new full-speed USB device number 85 using xhci_hcd
Aug 31 19:37:28 asx-comp kernel: [30552.068453] usb usb1-port2: attempt power cycle
Aug 31 19:37:28 asx-comp kernel: [30552.720388] usb 1-2: new full-speed USB device number 86 using xhci_hcd
Aug 31 19:37:28 asx-comp kernel: [30552.720605] usb 1-2: Device not responding to setup address.
Aug 31 19:37:29 asx-comp kernel: [30552.928404] usb 1-2: Device not responding to setup address.
Aug 31 19:37:29 asx-comp kernel: [30553.264219] usb 1-2: new full-speed USB device number 87 using xhci_hcd
Aug 31 19:37:29 asx-comp kernel: [30553.264411] usb 1-2: Device not responding to setup address.
Aug 31 19:37:29 asx-comp kernel: [30553.472295] usb 1-2: Device not responding to setup address.


I have got working USB device before but only one time. Yesterday I had the same situation - one time valid init and after reboot errors as above.
After night with dsiabled power first try todey - success but later it fails.

My bord is RockPro64 V2.1 2018-07-02 4GB
Linux - Debian 10 amd64

Does anybody have an idea what can be wrong?

Nutilius