05-11-2019, 01:06 PM
I didn't see a discussion group for the old Pine64, just the Pine64+ so the moderator will probably need to move it. I just purchased and installed the Pine wifi card for my board. It didn't have any instructions or ducumentation included so I assumed the installation would be automatic. Not so. The system doesn't appear to recognize the board...at least in the configuration. I'm not sure if drivers need to be installed or updated, etc. If been running on ethernet for some time and the systems been running pretty good...although slow but wireless would be nice. If I run iwconfig I get this:
dan@pine64:~$ sudo iwconfig
[sudo] password for dan:
eth0 no wireless extensions.
lo no wireless extensions.
wlan0 unassociated Nickname:"<WIFI@REALTEK>"
Mode:Managed Frequency=2.412 GHz Access Point: Not-Associated
Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
enxc8d719d80388 no wireless extensions.
so it appears the system sees is but that's about it Anybody know what's happening?
dan@pine64:~$ sudo iwconfig
[sudo] password for dan:
eth0 no wireless extensions.
lo no wireless extensions.
wlan0 unassociated Nickname:"<WIFI@REALTEK>"
Mode:Managed Frequency=2.412 GHz Access Point: Not-Associated
Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
enxc8d719d80388 no wireless extensions.
so it appears the system sees is but that's about it Anybody know what's happening?