PINE64

Full Version: Rock64 and USB 3.0 HDD + USB 2.0 CC2531 doungle
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hello.
I have Rock 64 with connected HDD to USB 3.0 and CC2531 doungle (Zigbee sniffer) to USB 2.0
In this configuration HDD works fine, but CC2531 work very bad - working distance to Zigbee devices is 2-3 meters (must be 10-15).
Then I disconnect HDD from USB 3.0 - CC2531 work fine! Zigbee devices connect at 10-15 meters from Rock64.
I try connect CC2531 to USB 3.0 (HDD is OFF) - and in this configuration also all working fine.

But I need connect HDD and CC2531 simultaneous...
Whats problem can be?
Hi,
have you tried to use an usb2 extension for your CC2531 dongle?
sometimes an usb3 connector near a wireless device can disturb the wireless transmission.
regards
(02-04-2019, 03:35 AM)pas059 Wrote: [ -> ]Hi,
have you tried to use an usb2 extension for your CC2531 dongle?
sometimes an usb3 connector near a wireless device can disturb the wireless transmission.
regards

Hi.
I try usb-extender (1 meters lenght) - and it's helped.
CC2531 working good, working distance Zigbee devices - 10-15 meters.
I will continue to experiment. Basic version - something (HDD+USB-SATA adapter) interferes with CC2531.
(02-04-2019, 03:35 AM)pas059 Wrote: [ -> ]Hi,
have you tried to use an usb2 extension for your CC2531 dongle?
sometimes an usb3 connector near a wireless device can disturb the wireless transmission.
regards

Thank you so much! I had been testing a few different things to try to solve this, connectig through the usb2 extender solved my issues!

Great!