PINE64

How to make a WiFi/BT connection via shell command?

Tried WiFi first but doesn't succeed yet.

The following is some log.

Environment
- - - - - - - - - -
Board : RockPro64
OS : bionic-minimal-rockpro64-0.6.59-273-arm64.img
WiFi/BT Module : ROCKPro64 2×2 MIMO Dual Band WIFI 802.11AC/BLUETOOTH 4.2 MODULE[url=https://www.pine64.org/?product=rockpro64-2x2-mimo-dual-band-wifi-802-11acbluetooth-4-1-module][/url]

Log
- - -

Quote:rock64@rockpro64:~$ uname -a
Linux rockpro64 4.4.132-rockchip-ayufan-273 #1 SMP Tue Jul 3 21:35:20 UTC 2018 aarch64 aarch64 aarch64 GNU/Linux

rock64@rockpro64:~$ sudo ip link set wlan0 up
RTNETLINK answers: Operation not permitted

rock64@rockpro64:~$ sudo ifconfig wlan0 up
SIOCSIFFLAGS: Operation not permitted

rock64@rockpro64:~$ networkctl | awk '/wlan/ {print $2}'
wlan0

rock64@rockpro64:~$ ifconfig
eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
inet6 fe80::ec26:f5ff:fe58:fd1f prefixlen 64 scopeid 0x20<link>
ether ee:26:f5:58:fd:1f txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 5 bytes 681 (681.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 24

lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1 (Local Loopback)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

rock64@rockpro64:~$ sudo lshw -c network
*-network:0 DISABLED
description: Wireless interface
physical id: 7
logical name: wlan0
serial: ac:83:f3:e6:25:16
capabilities: ethernet physical wireless
configuration: broadcast=yes driver=wl driverversion=0 multicast=yes wireless=IEEE 802.11
*-network:1
description: Ethernet interface
physical id: 8
logical name: eth0
serial: ee:26:f5:58:fd:1f
size: 10Mbit/s
capacity: 1Gbit/s
capabilities: ethernet physical tp aui bnc mii fibre 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=st_gmac driverversion=March_2013 duplex=half link=no multicast=yes port=MII speed=10Mbit/s

rock64@rockpro64:~$ rfkill list all
0: bt_default: Bluetooth
Soft blocked: no
Hard blocked: no
1: phy0: Wireless LAN
Soft blocked: no
Hard blocked: no
2: brcmfmac-wifi: Wireless LAN
Soft blocked: no
Hard blocked: no

rock64@rockpro64:~$ lsmod
Module Size Used by
zram 32768 6
lz4_decompress 16384 1 zram
lz4_compress 16384 1 zram
bcmdhd 1183744 0
rockchip_saradc 16384 0
snd_soc_rockchip_spdif 16384 2
snd_soc_rockchip_i2s 16384 4
snd_soc_rockchip_hdmi_dp 16384 0
ip_tables 24576 0
x_tables 32768 1 ip_tables
autofs4 40960 0
dw_hdmi_i2s_audio 16384 0

rock64@rockpro64:~$ nmcli c
NAME UUID TYPE DEVICE

rock64@rockpro64:~$ modinfo -p bcmdhd
dhd_doflow: (uint)
dhd_dpcpoll: (uint)
clockoverride:SDIO card clock override (int)
sd_msglevel: (uint)
sd_power: (uint)
sd_clock: (uint)
sd_divisor: (uint)
sd_sdmode: (uint)
sd_hiok: (uint)
sd_f2_blocksize: (int)
sd_f1_blocksize: (int)
g_assert_type: (int)
dhd_oob_gpio_numHD oob gpio number (int)
clm_path: (string)
info_string: (string)
op_mode: (int)
dhd_msg_level: (int)
iw_msg_level: (int)
wl_dbg_level: (int)
android_msg_level: (int)
config_msg_level: (int)
dhd_arp_enable: (uint)
dhd_arp_mode: (uint)
disable_proptx: (int)
firmware_path: (string)
nvram_path: (string)
config_path: (string)
dhd_watchdog_ms: (uint)
dhd_console_ms: (uint)
dhd_slpauto: (uint)
dhd_pkt_filter_enable: (uint)
dhd_pkt_filter_init: (uint)
dhd_master_mode: (uint)
dhd_watchdog_prio: (int)
dhd_dpc_prio: (int)
dhd_rxf_prio: (int)
dhd_dongle_ramsize: (int)
passive_channel_skip: (int)
instance_base: (int)
iface_name: (string)
dhd_idletime: (int)
dhd_poll: (uint)
dhd_intr: (uint)
dhd_sdiod_drive_strength: (uint)
dhd_txbound: (uint)
dhd_rxbound: (uint)
dhd_deferred_tx: (uint)
dhd_pktgen: (uint)
dhd_pktgen_len: (uint)
allow_delay_fwdl: (int)

Aesop