PINE64

Full Version: Rust on RTL8710 running FreeRTOS
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hey all.  I recently cobbled together a build system so that Rust could be used on the PADI / RTL8710.  It's basically the Ameba SDK, with some modifications to allow the Rust build to be linked in as a library.

You can read more about how it works here: https://polyfractal.com/post/rustl8710/

Fair disclaimer:  I know very little about embedded hardware, so a good chunk of the article is also about how to physically setup the PADI for SWD, UART, etc.

Hope this is helpful/interesting to someone! Smile
Awesome, thanks for cross-posting here. I dropped a couple of little PRs on it consisting of what I needed to do to get it to build on Arch Linux.
(01-05-2017, 07:12 AM)polyfractal Wrote: [ -> ]Hey all.  I recently cobbled together a build system so that Rust could be used on the PADI / RTL8710.  It's basically the Ameba SDK, with some modifications to allow the Rust build to be linked in as a library.

You can read more about how it works here: https://polyfractal.com/post/rustl8710/

Fair disclaimer:  I know very little about embedded hardware, so a good chunk of the article is also about how to physically setup the PADI for SWD, UART, etc.

Hope this is helpful/interesting to someone! Smile

Thanks, I will post on Pine64 PADI resource page.
Awesome! Thanks Smile

Basie: sorry for the delay, merged one of your PRs and the other I think was caused by a bad .gitignore on my end