PINE64

Full Version: Debian Base (3.10.102 BSP) not booting with battery attached
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Debian Base (3.10.102 BSP) is not booting when a battery is attached.  It boots for a split second and powers back off or goes into a boot loop.  However when the batter is disconnected it boots as expected.
Hiren,

The Pine64+ boards have a Power source jumper near the uSDcard.. is this jumper set?

My initial attempts to boot recent Debian linux images (base or xfce) failed when using the power button. The power LED lit after pressing the pwr btn then went off ~2sec later. Cold booting the board (disco/reconnect the pwr plug) booted these images successfully.

Perhaps a quick hard reset (button) with battery power would work.

Regards,

HenryD