Pinning of A/V jack
#1
Hello together,

I need an adapter / cable for video output of my Rock64 board.

Is this pinning of the plug correct?

   

TIP = GND
first RING after the TIP = video / cvbs
second RING after the TIP = right channel
SLEEVE = left channel

Is that correct?

Many thanks.
  Reply
#2
Hi,

according to schematic available on Rock64's resources page: 

L
---
R
---
CVBS_OUT
---
GND (tip)

(the arrow -v- show contact area, the big rectangle is most probably the end of the jack itself unless it's backward)
So you're right Smile.
  Reply
#3
Hello Michael,

thank you very much for confirmation Smile
  Reply
#4
(06-04-2018, 03:22 AM)Osiander Wrote: Hello Michael,

thank you very much for confirmation Smile

Hello Osiander!

Would you confirm if the suggested pinout combination worked for you? I actually read the schematics backwards as suggested here, I'm not an expert, but it is how understood the schematics and I'd just like to confirm before buying an A/V cable.

Thanks in advance, regards...
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)