Z-Wave module problem
#1
So I have the US Z-Wave module (Sigma) version without an adapter. 

Initially, it was working with the OpenHAB image from the wiki, but after adding the 4th device all devices stopped communicating.
I was getting some of them discovered as "Unknown Device" but once the module was reset completely they simply do not communicate at all. 

I have tried using a different build with OpenHAB as well as built the OpenZWave console. In either case I have no problem communicating with the module and getting it initialized but No communication from the devices is received. 
I see no communications error messages in the log either, I simply see no evidence of any communication from any device being received at all.

Is it possible the Z-Wave module itself is bad? I'm not sure how to test it at this point. 
Any suggestions would be greatly appreciated.
  Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
Question Z-Wave module pinout to make it compatible with Pi b+ ebretteville 59 82,959 07-12-2019, 08:55 AM
Last Post: kris240376
Sad Z-Wave and openzwave+node-openzwave-shared saro 2 6,225 09-01-2017, 05:22 AM
Last Post: saro
  Z-Wave - Full and Low Power Inclusion mode B34N 1 4,197 03-26-2017, 06:03 PM
Last Post: B34N
  KICAD Quick Lib and Module Generator mbt28 1 4,612 02-12-2017, 10:45 PM
Last Post: tllim
  Z Wave Module and still using GPIO bang 2 5,704 01-16-2017, 03:12 AM
Last Post: bang
  Z-Wave US module with adapter aegrotatio 4 7,136 01-08-2017, 12:03 AM
Last Post: aegrotatio
  RaZberry Module (z-wave) need support to get it working! Luxus 13 18,720 11-03-2016, 02:04 AM
Last Post: Luxus
Video Australia/New Zealand Z-Wave module Jnimmo 46 53,453 10-02-2016, 02:25 PM
Last Post: tllim
  LCD screen problem; borahan 4 6,715 09-27-2016, 07:16 PM
Last Post: dkryder
  [EU] Z-Wave module tutorials? meowbot 2 5,259 09-13-2016, 07:54 PM
Last Post: Ghost

Forum Jump:


Users browsing this thread: 1 Guest(s)