(05-16-2020, 06:05 AM)nohandlebars Wrote:(05-15-2020, 11:55 AM)Lumat Wrote:(05-15-2020, 11:29 AM)nohandlebars Wrote: I boot this with the serial cable connected however it always stops at the following two lines:
Code:rkclock0 at mainbus0
rkclock1 at mainbus0
Are you using the serial cable from pine store? If so it's 5v instead of 3.3v and it creates all sorts of problems such as that one.
I am using the serial cable from the store. I have another one that I connect to the GPIO pins of my SBCs, am I able to use that on the PineBook Pro?
I also had another one for GPIO pins so what I did was cutting the 3.5mm jack from pine store and then joining cables to the other one I had with 3.3v. If you open the one from the pine store you will see it's 5v. My pbp was booting all the way through just the connection gets stuck right there when it loads the serial device and we stop seeing after that.
(05-16-2020, 07:38 AM)SKG Wrote: I really hope that no serial cable is need. I don't have one and I don't want one.
One misses out so much simply flashing an image. Easy and fast has a price and that's deeper understanding and knowledge. OpenBSD's documentation is excellent and I really hope the UNIX way never changes.
“Linux people do what they do because they hate Microsoft. We do what we do because we love Unix."
– Theo de Raadt