01-06-2017, 03:15 AM
(This post was last modified: 01-06-2017, 03:33 AM by Learnincurve.)
Hi,
I ordered one of these and see that with some small modifications, it can be turned into a very sleek, standing case.
I'm dropping the corner brackets, which are only needed to protect the screen if the unit is used as a playbox. Mine will be standing permanently in my HiFi shelves in picture-frame posture.
That brings me to my question or request.
If anyone knows of a source of some flat aluminium brackets, about 3mm thick, 1-2cm wide and bent at a 65°/115° angle, that could be cut to length and polished, I'd be happy to know about them. I don't care what they're originally intended for. One end will be bolted to sides of the back of the C4 enclosure, while the other will sit on the shelf, supporting the unit at a nice, 65°(ish) angle.
Of course I can manufacture them myself if necessary, but bending two, exactly matched angles from flat aluminium may be difficult.
Cheers!
--Marius--
I ordered one of these and see that with some small modifications, it can be turned into a very sleek, standing case.
I'm dropping the corner brackets, which are only needed to protect the screen if the unit is used as a playbox. Mine will be standing permanently in my HiFi shelves in picture-frame posture.
That brings me to my question or request.
If anyone knows of a source of some flat aluminium brackets, about 3mm thick, 1-2cm wide and bent at a 65°/115° angle, that could be cut to length and polished, I'd be happy to know about them. I don't care what they're originally intended for. One end will be bolted to sides of the back of the C4 enclosure, while the other will sit on the shelf, supporting the unit at a nice, 65°(ish) angle.
Of course I can manufacture them myself if necessary, but bending two, exactly matched angles from flat aluminium may be difficult.
Cheers!
--Marius--
