RaZberry Module (z-wave) need support to get it working!
#11
Since it is attached on the Pi Header, it is probably using the pin 8 and 10, therefore it is connected to UART2 of the A64 according to PinA64 schematic, so try it with /dev/ttyS2.
  Reply


Messages In This Thread
RE: RaZberry Module (z-wave) need support to get it working! - by martinayotte - 06-28-2016, 08:51 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
Question Z-Wave module pinout to make it compatible with Pi b+ ebretteville 59 82,977 07-12-2019, 08:55 AM
Last Post: kris240376
Question RGB LED Matrix support? foxnox 1 4,250 12-29-2017, 06:52 PM
Last Post: psychedup
Sad Z-Wave and openzwave+node-openzwave-shared saro 2 6,229 09-01-2017, 05:22 AM
Last Post: saro
Question Is SPI Working? User 3332 64 96,101 08-12-2017, 03:14 PM
Last Post: louwie17
  Z-Wave - Full and Low Power Inclusion mode B34N 1 4,202 03-26-2017, 06:03 PM
Last Post: B34N
  KICAD Quick Lib and Module Generator mbt28 1 4,612 02-12-2017, 10:45 PM
Last Post: tllim
  Z Wave Module and still using GPIO bang 2 5,704 01-16-2017, 03:12 AM
Last Post: bang
  Z-Wave US module with adapter aegrotatio 4 7,139 01-08-2017, 12:03 AM
Last Post: aegrotatio
  Dallas 1-Wire Support ItsDave 31 37,896 12-27-2016, 08:30 PM
Last Post: ed_mann
  touch screen not working mike280z 1 3,603 12-22-2016, 12:46 PM
Last Post: Bluphire

Forum Jump:


Users browsing this thread: 1 Guest(s)