Using GPIO interrupts
#3
I installed gpiolib packages (libgpiod2, libgpiod-dev, gpiod - all v1.6.2). Then I used `sudo gpiomon 4 28` and `sudo gpiomon -B pull-down 4 28` and they both give exactly the same output as sysfs. Also when I disconnect my whole button setup and touch the input with my finger, the command spits out RISING and FALLING interrupts no matter whether I enable pull-down or pull-up or disable them.
  Reply


Messages In This Thread
Using GPIO interrupts - by antonlyap - 06-30-2021, 06:39 AM
RE: Using GPIO interrupts with sysfs and epoll - by antonlyap - 06-30-2021, 10:06 AM
RE: Using GPIO interrupts - by antonlyap - 06-30-2021, 01:32 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  GPIO on the RockPro64 - all pins high? colinmarc 2 1,523 11-18-2022, 10:20 AM
Last Post: colinmarc
  GPIO Expander HAT for ROCKPro64 and Quartz64 CounterPillow 7 5,189 07-18-2022, 10:05 PM
Last Post: zer0sig
  GPIO performance 100x slower compared to Raspberry Pi 3 axelf 9 9,516 08-19-2020, 04:41 PM
Last Post: Gienek
  GPIO in sleep mode Mentaluproar 2 3,293 04-08-2019, 03:50 PM
Last Post: Mentaluproar

Forum Jump:


Users browsing this thread: 1 Guest(s)