I need 4 UARTs, to use board as controller for home automatization: 1 - ZeegBee, 1 - GSM, 1 - RS485, 1 - M-bus. But in documentation, there are only 2 gpio uarts enabled for user. I wouldn't like to use external usb converters, this interfaces should be located on my expansion board, connected to the rock64 by GPIOs. Is there any solutions to solve my problem?
|
UARTs from GPIO headers
|
| Messages In This Thread |
|
UARTs from GPIO headers - by maks.dav - 10-25-2020, 02:23 AM
RE: UARTs from GPIO headers - by tllim - 10-26-2020, 09:17 PM
RE: UARTs from GPIO headers - by martinayotte - 10-27-2020, 12:08 PM
RE: UARTs from GPIO headers - by maks.dav - 10-30-2020, 07:44 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
|
Rock64 usb2.0 Power Control Floating GPIO Tutorial Files & Notes | MarkHaysHarris777 | 6 | 13,197 |
01-15-2023, 10:36 AM Last Post: ds00 |
| Configuring Python GPIO Pin Control Rock64 | www139 | 3 | 7,619 |
06-22-2021, 06:57 AM Last Post: Mrfixit2001 |
|
| Help connecting a dvb board in the right gpio pins | cosmodeal | 0 | 2,164 |
11-11-2020, 12:48 PM Last Post: cosmodeal |
|
| GPIO extension cable fault | viguzzz | 12 | 13,362 |
05-18-2018, 04:03 AM Last Post: viguzzz |
|
|
Rock64 GPIO | Nak64Rbit | 5 | 7,560 |
04-04-2018, 12:53 AM Last Post: hryst |
| gpio driver porting from an r-pi3b | gene83 | 9 | 10,521 |
12-02-2017, 03:44 AM Last Post: xalius |
|
Users browsing this thread: 1 Guest(s)