05-10-2016, 03:01 AM
Hello -
After several hours wasted trying to get the board to boot up (don't use unetbootin!) I finally managed to get Ubuntu installed
on the Pine 64 2Gb. I am trying to get it to read a Dallas 1-wire sensor from the GPIO Headers (Using pin 4).
I've installed the ported GPIO library for the Pi which doesn't seem to be able to read the device.
Has anyone managed to read data from the Dallas 1-Wire interface yet?
Also I read somewhere that the Pine64 supports analog connections - what pins support analog sensors?
After several hours wasted trying to get the board to boot up (don't use unetbootin!) I finally managed to get Ubuntu installed
on the Pine 64 2Gb. I am trying to get it to read a Dallas 1-wire sensor from the GPIO Headers (Using pin 4).
I've installed the ported GPIO library for the Pi which doesn't seem to be able to read the device.
Has anyone managed to read data from the Dallas 1-Wire interface yet?
Also I read somewhere that the Pine64 supports analog connections - what pins support analog sensors?
