+- PINE64 (https://forum.pine64.org)
+-- Forum: ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=98)
+--- Forum: Linux on RockPro64 (https://forum.pine64.org/forumdisplay.php?fid=101)
+--- Thread: Unable to boot ayufan images (/showthread.php?tid=7312)
Unable to boot ayufan images - vman - 03-27-2019
I ran into an interesting problem, I can boot the mrfixit2001 Debian image without any issue but for some reason I am unable to boot up any other image. Even more problematic is that the serial port just does not seem to work at all, I suppose I might have at some point had the USB-Serial set to 5v and blew the UART, only reason I can think why I cannot get anything out of the serial connection, so I cannot really debug the low level boot messages.
My question, does anyone what the config is mrfixit2001 use for the kernel build? Ideally I would like to use Fedora, but I will settle for Bionic until I can figure out why the serial is not working 0 or maybe get a new board...
Any hints would be greatly appreciated
VMan