Cheap way to secure back - elastic band?! - Printable Version +- PINE64 (https://forum.pine64.org) +-- Forum: PineTime (https://forum.pine64.org/forumdisplay.php?fid=134) +--- Forum: General Discussion on PineTime (https://forum.pine64.org/forumdisplay.php?fid=135) +--- Thread: Cheap way to secure back - elastic band?! (/showthread.php?tid=12819) |
Cheap way to secure back - elastic band?! - andystratton - 01-18-2021 Hello Everyone Here's a couple of pictures of how a strong elastic band can hold the back in place on your wrist - and when you put the watch on charge, you can slip the band round the charger (not shown) - though the back tends to remain the charger when you take the watch off charge. Hope this helps - Andy https://photos.app.goo.gl/XTN8tDkLirKYUPnz8 https://photos.app.goo.gl/frVnhw9DwigeRB5r9 RE: Cheap way to secure back - elastic band?! - Energy Content - 01-26-2021 Thanks, a rubber band is a good idea! What I would really like is to have the back be attached with screws. Is this an option for the future? RE: Cheap way to secure back - elastic band?! - Alfiory - 02-08-2021 There is this 3d print that works : https://www.thingiverse.com/thing:4651462 I've tested it, it works well and is certainly easier to put/take off than an elastic band I think. It's certainly improvable, maybe to hold the back a bit tighter for example. RE: Cheap way to secure back - elastic band?! - zer0sig - 02-18-2021 I'm using a black elastic band right now but this 3D printed cover sounds good. I keep looking for an excuse to buy one but still haven't pulled the trigger. It might just happen soon if I can find a fairly affordable, fairly flexible printer that can print decent sized stuff. RE: Cheap way to secure back - elastic band?! - mfashby - 03-10-2021 I've used blu-tack as a (relatively) easily removable glue. |